Thanks for stopping by today! This is my third card in the Scraps to Stunning card series.
For this card I used scraps from the Hand-Penned Designer Series paper. I brought in the “One Happy Family” sentiment stamp set, the “Iconic Dies” , the Scalloped Contours Dies and of course the “Hammered Metal 3D embossing folder.
Don’t forget I used Designer Sereis scraps for this card so all of the strips are different sizes. I am showing sizes for the card stock that I used for the Flower and leaves but those were also scraps from my bin.
Here are the card cuts, instructions, supply list and video for this card.
Please don’t forget to follow me and leave me a comment below. I’d love to hear from you!
Card cuts: DSP = Designer Series Paper
Card Base – Basic Black 5 1/2 x 8 1/2 scored at 4 1/4
Layer 1 – Basic White – 4 x 5 1/4
Layer 2 – Various Strips from the Hand-Penned DSP
Layer 3 – Basic Black – 2 1/4 x 3 1/2
Layer 4 – Basic White – 1 1/2 x 3
Layer 5 – Mint Macaron – 2 x 3
Layer 6 – Daffodil Delight – 2 x 2
Layer 7 – Hand-Penned DSP – 1/2 x 5 1/4
Layer 8 – Basic White – 4 x 5 1/4
Instuctions:
1. Layer 1 & 2 – Adhere your strips of DSP scraps to Layer 1 leaving a small border in between each strip.
- Once all strips are adhered run it through the Hammer 3D embossing Folder
- Wrap the ribbon around the center.
- Adhere to the card front.
- Adhere to the card front using Dimensionals straddling the ribbon as shown.
- Using the Scalloped Contours Dies cut out a Scalloped label
- Adhere it to Layer 3.
- Adhere them to the card front as shown.
- Adhere to the card front as shown.
- Apply Genial Gems as desired
- Adhere to the inside of the card.
Product List