At first glance the dies can be a little intimidating but once you use them they will amaze you! So easy to fit together to form this beautiful flower! I used the entire Peony Garden Suite to design and make this card.
Stampin Up® has out done themselves with the design for this flower. The color combo’s blend so well together. Hope it give you some inspiration to create a bunch of cards!
Project Recipe:
-
Cut Instructions: DSP = Designer Series PaperCard Base – Thick Whisper White – 5 1/2 x 8 1/2 scored at 4 1/4.Layer 1- Peony Garden DSP – 2 1/2 x 5 1/2
Layer 2 – Basic Gray – 2 x 4 1/4
Layer 3 – Gray Granite – 3 x 4
Layer 4 – Square Vellum Doily
Layer 5 – Old Olive – 2 x 3
Layer 6 – Pear Pizzaz – 2 x 2
Layer 7 – Petal Pink – 4 x 5 1/4
Layer 8 – Basic Gray – 3/4 x 1
Layer 9 – Basic Gray – 3/4 x 2 1/2
Layer 10 – Peony Garden DSP – 1/2 x 5 1/2 -
Layer 1 – Adhere to card front about 1/4″ from right edge.
-
Layer 2 – Using Whisper White craft ink stamp the triangle image several times creating a pattern onto the sheet.
-
Adhere to the card front about 2″ from top edge.
-
Layer 3 – Run through the Dainty Diamonds 3D embossing folder.
-
Adhere to card front about 3/4″ from top edge and 1/2″ from left side.
-
Layer 4 – Using mini glue dots adhere to Layer 3 keeping the glue dots in the center that will be covered.
-
Layer 5 – Cut out all three sizes of leaves with the Peony Dies.
-
Layer 6 – Cut out all three sizes of leaf details with the Peony Dies. Then attach to Layer 5 leaves.
-
Adhere leaves onto Layer 4 as desired just make sure the flower will cover the inside stems.
-
Layer 7 – Cut out all four flower pieces.
-
Using a sponge dauber highlight the petals with Blushing Bride ink.
-
Build flower by starting with largest piece to smallest piece. Each one will slide into the previous one and line up on the back side. (See Video link below)
-
Layer 8 – cut out the flower center then slip into the center of the flower.
-
Using Stampin Dimensionals adhere the Flower to the card front placing in center of Layer’s 3 & 4 and layering over leaves.
-
Layer 9 – Stamp sentiment in Whisper White Craft ink. (If you have a stamparatus I would use it so you can get a good shade of white on the sentiment)
-
Adhere to the card front in the lower left of Layer 3 & 4 about 1/4″ from bottom edge of Layer 3 and flush on the left side.
-
Adhere three of the white Elegant Faceted Gems as shown.
-
Layer 10 – Adhere to the inside of card along the right edge top to bottom.
-
Stamp sentiment in Basic Gray ink in the center.
Here’s a Link to a video that I did on my Business site Julie’s Creative Stampin with this card and the next 2 that I will be adding to my blog! Don’t forget to check by in a few days to check out the other cards I did with this Suite!
To purchase supplies for this card just click on the pictures below!
Product List