Thanks for popping in today! I am again showing a card I made with the Bloom Where You’re Planted Suite by Stampin Up®.

This suite includes the Plentiful Plants Bundle, Bloom Where You’re Planted Designer Series Paper and Paper Lattice.

This suite makes it easy to create beautiful and unique cards.

If you’d like to be notified each time I add a card to my blog just add your email to the right under the “Follow Me” section.

Card cuts, instruction and Supply list:

Card Cuts

Card Base – Thick Basic White – 5 1/2 x 8 1/2 scored at 4 1/4

Layer 1 – Bloom Where You’re Planted DSP – 4 1/8 x 5 3/8

Layer 2 – Bloom Where You’re Planted DSP – 3 1/4 x 5

Layer 3 – Paper Lattice

Layer 4 – Basic White 3 1/2 x 5 (Hanger, plant, label -1/2 x 2 1/8)

– Garden Green – 2 1/2 x 3

– Evening Evergreen – 1 1/2 x 1 1/2

– Gray Granite – 1 x 1

– Cajun Craze – 1 x 1

Layer 5 – Evening Evergreen – 3/4 x 2 3/8

Layer 6 – Bloom Where You’re Planted DSP – 1/2 x 5 1/2

Instructions:

1. Layer 1 – Adhere to the card front.

2. Layer 2 – Center onto Layer 1

3. Layer 3 – Layer onto Layer 2 lining up exactly

4. Layer 4 – Basic White piece –

Using Just Jade ink stamp the vine plant leaving enough room to cut out.
Using Cajun Craze ink stamp the pot as shown, leaving room to cut out.
Now using the Perfect Plants Dies cut out the vine plant and the pot and cut out a the macrame hanger.
Next cut out a strip that is 1/2 x 2 1/8 then using Evening Evergreen ink stamp the sentiment.

– Garden Green

Stamp the large fern plant using Garden Green then cut out using the dies.

– Gray Granite

Using the Perfect Plant Dies cut out one of the small plant holders

– Cajun Craze

Using the same die as above cut out another small plant holders

– Evening Evergreen

Using the dies cut out one of the small aloe plants

Adhere all the pieces to the card front as shown. Except for the sentiment strip. (Note: Macrame Hanger and pot are popped up with dimensionals)

5. Layer 5 – Adhere the sentiment strip from above to this piece then adhere them both to the card front as shown.

6. Layer 6 – Adhere along the bottom edge of the inside of the card.

Using Evening Evergreen ink, stamp the sentiment as shown.

7. Adhere one of the rhinestones to the hole in the top of the Macrame holder.

Hope you enjoyed this card and thanks again for stopping by my blog today. Here is the supply list of products used to make this card! If you would like to purchase any of the products just click on the pictures below!

NOTE: I have listed the suite as well as the individual items used to make this card! I did this because it’s easier to enter just one item number if your interested in the suite. Also you can purchase the stamp set and punch separately but I always list them as a bundle you save 10% by purchasing bundles as a bundle!

If you have any questions about ordering please feel free to contact me!

Product List